Scissor Lift Certification Mesa

Scissor Lift Certification Mesa - Scissor lift platforms are made use of at work sites in order to enable tradespeople - like for example iron workers, welders and masons - to reach their work. Making use of a scissor lift platform is normally secondary to their trade. Thus, it is essential that all operators of these platforms be trained correctly and licensed. Regulators, industry and lift manufacturers work together to ensure that operators are trained in safely using work platforms.

Work platforms are otherwise referred to as manlifts or AWPs. These equipment are stable and easy to operate, although there is always some risk as they lift individuals to heights. The following are various key safety concerns common to AWPs:

To be able to protect those working around work platforms from accidental power discharge because of close working proximities to wires and power lines, there is a minimum safe approach distance (also referred to as MSAD). Voltage can arc across the air and cause injury to personnel on a work platform if MSAD is not observed.

Care must be taken when lowering a work platform to ensure steadiness. The boom must be retracted, moving the load toward the turntable. This would help maintain steadiness if the -platform is lowered.

The rules about tie offs do not mandate people working on a scissor lift to tie themselves off. Various groups will however, need their employees to tie off in their employer guidelines, job-specific risk assessments or local regulations. The anchorage provided by the manufacturer is the only safe anchorage to which harness and lanyard combinations must be connected.

Observe the maximum slope rating and do not go over it. A grade could be measured by laying a board or straight edge on the slope. A carpenter's level can then be placed on the straight edge and raised until the end is level. By measuring the distance to the ground and dividing the rise by the length of the straight edge, then multiplying by 100, you can determine the percent slope.

A regular walk-around inspection has to be performed to determine if the unit is mechanically safe. A location assessment determines if the work area is safe. This is important especially on changing construction locations because of the possibility of obstacles, contact with power lines and unimproved surfaces. A function test needs to be carried out. If the unit is utilized safely and properly and proper shutdown measures are followed, the possibilities of accidents are greatly lessened.

Click to Download the pdf